comp.lang.idl-pvwave archive: archive » Help: IDL slicer in IRIX 5.2??

Home » Public Forums » archive » Help: IDL slicer in IRIX 5.2??

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Help: IDL slicer in IRIX 5.2?? [message #4193 is a reply to message #4104]

Fri, 05 May 1995 00:00

jeffb
Messages: 2
Registered: May 1995

Junior Member

I'll answer this one myself (thanks to RSI).
> I run IDL 2.4 on an SGI Indigo running IRIX 5.2.
> For some reason the slicer is not working; it won't display
> anything at all on the right side of its window (where output
> usually is displayed).

Thanks to RSI for giving me the answer to this one.
The slicer is actually working fine. The problem is that the screen size
limits the size of the slicer window (horizontally), so that the output
doesn't fit on the right side of the window (next to the controls).
It ends up below the controls, so you have to increase the size of the
window vertically to see it.

Of course, this means the slicer takes up the entire screen. There's
a better way: change the default font of the widget to a smaller one;
then everything fits fine. The command for this is:
widget_control,default_font='6x9'

The font is tiny and hard to read, but at least it works.

Jeff

Report message to a moderator

[Message index]

		Help: IDL slicer in IRIX 5.2?? By: jeffb on Thu, 04 May 1995 00:00
		Re: Help: IDL slicer in IRIX 5.2?? By: Richard Olsen on Mon, 08 May 1995 00:00
		Re: Help: IDL slicer in IRIX 5.2?? By: jeffb on Fri, 05 May 1995 00:00

Previous Topic:	IMSL routine access from IDL
Next Topic:	Re: Saving SGI RGB files...

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 18:59:07 PDT 2025

Total time taken to generate the page: 0.00467 seconds