comp.lang.idl-pvwave archive: archive » Re: how to rerun subroutine only?

Home » Public Forums » archive » Re: how to rerun subroutine only?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: how to rerun subroutine only? [message #42728 is a reply to message #42726]

Mon, 21 February 2005 12:22

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

u2s5thmember@yahoo.com writes:

> this is probably a beginner question, so I appreciate your patience:
>
> Suppose I compile & run a top level program, then it enters a
> subroutine. Then suppose I want the code to stop somewhere in the
> subroutine so I can plot variables or check on/plot the results of a
> calculation... or say the subroutine encounters an error. then I might
> change something in the subroutine and need to rerun the subroutine.
>
> right now I recompile the subroutine then rerun the entire code
> starting from the beginning of the toplevel program, when all I really
> need to do is have idl redo the calculations from the beginning of the
> subroutine.
>
> is there a way to do this?

No. :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: how to rerun subroutine only? By: u2s5thmember on Mon, 21 February 2005 14:52
		Re: how to rerun subroutine only? By: kashyap on Mon, 21 February 2005 13:32
		Re: how to rerun subroutine only? By: Michael Wallace on Mon, 21 February 2005 12:57
		Re: how to rerun subroutine only? By: David Fanning on Mon, 21 February 2005 12:22

Previous Topic:	Re: tick label problem
Next Topic:	widget_base alignment question

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 03:03:44 PDT 2025

Total time taken to generate the page: 0.72211 seconds