comp.lang.idl-pvwave archive: archive » error

Home » Public Forums » archive » error_state.code

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

error_state.code [message #43243]

Thu, 24 March 2005 06:18

Bringfried Stecklum is currently offline

Bringfried Stecklum
Messages: 75
Registered: January 1996

Member

Hello,

back in the times of 5.6 I wrote a program which accepts input from /dev/stdin. I used
the on_ioerror command to test the end of the input, i.e. a ^D at the prompt yielded the
!error_state.code of -236 which was used to terminate the input. I noticed that this piece of
software did not work anymore with IDL 6.1. The reason is that the error_state codes obviously
differ: EOF is now -265. Can a brave soul point me to the section of the documentation where
these codes are summarized (as well as the changes). I have not found that yet.

with kind regards,

Bringfried Stecklum

Report message to a moderator

[Message index]

error_state.code

By: Bringfried Stecklum on Thu, 24 March 2005 06:18

Previous Topic:	Little CREATE_STRUCT issue
Next Topic:	Re: error_state.code

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 01:03:53 PDT 2025

Total time taken to generate the page: 1.92260 seconds