comp.lang.idl-pvwave archive: archive » Re: slicer3 for a series of plots

Home » Public Forums » archive » Re: slicer3 for a series of plots

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: slicer3 for a series of plots [message #43350 is a reply to message #43348]

Fri, 08 April 2005 05:47

David Jackson
Messages: 8
Registered: October 2003

Junior Member

Hi all,

I received a few responses to my question suggesting that perhaps I wasn't
completely clear in my original post. Let me try to be a little clearer.

Let's assume I have data for a 3-D trajectory in space and I use xplot3d to
look at this space curve. Now assume I have several hundred of these
trajectories and I use xplot3d to look at them. The result is a very nice
3-D plot that I can manipulate but because there are so many trajectories,
it is somewhat difficult to see what's going on. Thus, I would LIKE to be
able to essentially use a slicer type program to see where these
trajectories intersect a moveable plane.

The best I've been able to do is to use the plot command to make 2-D images
for each of the separate planes and then animate them as if the slice was
being "moved up the cube". This works really well but I would prefer that I
have an actual cube with a slice that I can manipulate so that it
demonstrates that these are really slices from a 3-D volume.

David

Report message to a moderator

[Message index]

		Re: slicer3 for a series of plots By: David Fanning on Fri, 08 April 2005 06:13
		Re: slicer3 for a series of plots By: David Jackson on Fri, 08 April 2005 05:47
		Re: slicer3 for a series of plots By: David Jackson on Fri, 08 April 2005 05:16
		Re: slicer3 for a series of plots By: David Fanning on Thu, 07 April 2005 12:47

Previous Topic:	Re: Overlay contours on JPEG
Next Topic:	Re: DLM error

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 11:48:35 PDT 2025

Total time taken to generate the page: 0.00231 seconds