comp.lang.idl-pvwave archive: archive » Re: Object graphics output police (iImage)

Home » Public Forums » archive » Re: Object graphics output police (iImage)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Object graphics output police (iImage) [message #44092 is a reply to message #44091]

Fri, 13 May 2005 08:34

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Randall Skelton writes:

> Can someone explain if there is a way to 'fix' the iTools problem
> demonstrated in the code below. The problem is that the image plotted
> in the iMap call does not export to a vector postscript cleanly
> (File->Export->'To File'->myFile.eps). Instead of getting a white
> masked area outside of the map projection, I get black in the eps file.
> None of the bitmap outputs suffer the same. I've tinkered with the
> CHANNEL and CLIP_PLANES keywords but was unable to make this go away :(

Sadly, this is pretty much what I would have expected
in this case. The truth is, the vector implementation
is just limited when it comes to textured overlays,
which is what I think this is. :-(

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: Object graphics output police (iImage) By: Randall Skelton on Fri, 13 May 2005 10:24
		Re: Object graphics output police (iImage) By: Randall Skelton on Fri, 13 May 2005 09:42
		Re: Object graphics output police (iImage) By: Karl Schultz on Fri, 13 May 2005 09:41
		Re: Object graphics output police (iImage) By: David Fanning on Fri, 13 May 2005 08:34

Previous Topic:	itools crash with suse 9.0
Next Topic:	Re: itools crash with suse 9.0

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 06:11:09 PDT 2025

Total time taken to generate the page: 0.71963 seconds