comp.lang.idl-pvwave archive: archive » Re: problem using p.multi in IDL 5.3/IRIX

Home » Public Forums » archive » Re: problem using p.multi in IDL 5.3/IRIX

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: problem using p.multi in IDL 5.3/IRIX [message #48117 is a reply to message #48116]

Tue, 28 March 2006 07:35

Paolo Grigis
Messages: 171
Registered: December 2003

Senior Member

Something like

device,ysize=28,yoffset=1

after the set_plot,'PS' command
could solve your problem. The sizes are in cm, fit them to
your paper size.

Ciao,
Paolo

William C. Keel wrote:
> OK, I throw myself on the good offices of the group. Running IDL 5.3
> under SGI IRIX 6.15, I can't manage to get two plots up-and-down
> on a portrait PostScript page. No setting of !p.multi that I've
> tried does it. I can get two plots sharing the top half of the page,
> each very wide and short, or the ostensible lower plot landing on
> top of the upper one (overplotted, as far as I can tell) with a message:
> DEVICE: PostScript preview incompatible with multiple pages
>
> I would have thought that setting !p.multi=[2,1,2] or [0,1,2] would get me
> there, but that results in two plots squeezed vertically sharing the
> top half of the page. Feel free to point out what blindingly obvious
> thing I'm repeatedly missing - we have two teenagers at home, so
> I'm under no illusions of mental adequacy.
>
> Thanks,
>
> Bill Keel
> Astronomy, University of Alabama

Report message to a moderator

[Message index]

		Re: problem using p.multi in IDL 5.3/IRIX By: William C. Keel on Tue, 28 March 2006 13:28
		Re: problem using p.multi in IDL 5.3/IRIX By: David Fanning on Tue, 28 March 2006 07:50
		Re: problem using p.multi in IDL 5.3/IRIX By: Paolo Grigis on Tue, 28 March 2006 07:35

Previous Topic:	Re: Removing repeating array values
Next Topic:	Re: how to use IDL performing the Canonical correlation analysis(CCA)?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 13:03:53 PDT 2025

Total time taken to generate the page: 0.07990 seconds