comp.lang.idl-pvwave archive: archive » Re: IVolume/isosurface

Home » Public Forums » archive » Re: IVolume/isosurface

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IVolume/isosurface [message #49197]

Fri, 07 July 2006 11:09

Kenneth P. Bowman
Messages: 585
Registered: May 2000

Senior Member

In article <Ic-dnWqhn7QrBTPZnZ2dnUVZ_s-dnZ2d@comcast.com>,
Michael Galloy <mgalloy@gmail.com> wrote:

> Karl's suggestion will fix this programmatic example too. You just need
> to insert a
>
> vol_obj->select
>
> after creating an isosurface (and before creating the next isosurface).
> See the code below.
>
> Mike

Ah ha! That was not obvious to me. (But being nearly superannuated*,
it is not surprising that it is not obvious.)

Thanks, Ken

*superannuated - adj., cause to become obsolete through age or new
technological or intellectual developments.

Report message to a moderator

[Message index]

		Re: IVolume/isosurface By: Kenneth P. Bowman on Fri, 07 July 2006 11:09
		Re: IVolume/isosurface By: Michael Galloy on Fri, 07 July 2006 10:23
		Re: IVolume/isosurface By: Kenneth P. Bowman on Thu, 06 July 2006 16:30
		Re: IVolume/isosurface By: Karl Schultz on Thu, 06 July 2006 15:08

Previous Topic:	Re: reading past leading and training bytes
Next Topic:	Re: Avoid loop in matrix operation

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 11:22:47 PDT 2025

Total time taken to generate the page: 0.47987 seconds