comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: MachTen and IDL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: MachTen and IDL [message #4931 is a reply to message #4930]

Thu, 24 August 1995 00:00

thompson
Messages: 584
Registered: August 1991

Senior Member

phil@peace.med.ohio-state.edu (Phil) writes:

> I recently (1 hr ago) installed MachTen and the X option on my PowerPC
> and have been playing with various aspects of the software to see what
> it can do. While I am initially pleased I notice a slight problem.

> When I use IDL and try to run some simple widgets. The widgets that I
> have a too large to fit on the screen. Therefore, I don't have access
> to certain sliders, buttons, etc. Is there anyway around this
> problem? Can I put a slider widget on the base widget to slide the
> whole base up and down?

> Any suggestions would be greatly appreciated.

Yes, if you use the keywords X_SCROLL_SIZE and Y_SCROLL_SIZE in the call to
WIDGET_BASE, you can then put slide bars around the entire widget.

Bill Thompson

Report message to a moderator

[Message index]

		Re: MachTen and IDL By: Eric R. Stephens on Fri, 25 August 1995 00:00
		Re: MachTen and IDL By: Richard Olsen on Thu, 24 August 1995 00:00
		Re: MachTen and IDL By: thompson on Thu, 24 August 1995 00:00

Previous Topic:	Re: Problems with hires maps with IDL v4.0.1
Next Topic:	Re: pvwave plot windows

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:17:27 PDT 2025

Total time taken to generate the page: 0.00434 seconds