comp.lang.idl-pvwave archive: archive » 3D triangulation of x,y,z vertices

Home » Public Forums » archive » 3D triangulation of x,y,z vertices

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

3D triangulation of x,y,z vertices [message #50453]

Sun, 01 October 2006 06:20

Thomas Launey
Messages: 25
Registered: September 1999

Junior Member

Hello,

I have a 3D object defined by its surface triangles. The connectivity
is a bit messed up with some faces normals pointing inward (toward the
inside of the object). Since I have all the points describing the
surface, I thougth that it would be easy to re-triangulate the x,y,x
vertices but apparently, I am missing the obvious...
What I did is:
Qhull, oldverts, tetrahedra, /delaunay, connectivity=connectivity
newconn = TETRA_SURFACE (oldvert, connectivity)

It fails however because the connectivity list returned by the Delaunay
triangulation is not recognized as a proper connectivity list for
tetrahedra. The IDL doc actually describe the 'connectivity' returned
by Qhull as an adjacency list. I tried to reformat it but without
success.
Any help or pointer would be very much appreciated .
Thanks,
Thomas

Report message to a moderator

[Message index]

3D triangulation of x,y,z vertices

By: Thomas Launey on Sun, 01 October 2006 06:20

Previous Topic:	read SCIAMACHY NO2 hdf files
Next Topic:	Re: read SCIAMACHY NO2 hdf files

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Dec 05 09:49:48 PST 2025

Total time taken to generate the page: 0.01504 seconds