comp.lang.idl-pvwave archive: archive » Re: Is it possible to use wire mesh and display the surface as a solid at the same time?

Home » Public Forums » archive » Re: Is it possible to use wire mesh and display the surface as a solid at the same time?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Is it possible to use wire mesh and display the surface as a solid at the same time? [message #50695]

Thu, 12 October 2006 11:59

yy
Messages: 14
Registered: September 2006

Junior Member

I tried the second way you suggested. It works pretty well! Thank you!

Jingyi
David Fanning wrote:
> yy writes:
>
>> I'm trying to use IDLgrSurface to map a colored image onto an
>> elevation data set. I want to show both the wire mesh such that
>> I can see the curvature of the surface and the solid image data.
>> In other words, I want to use both the image when STYLE=1
>> and the image when STYLE=2 as TEXTURE_MAP. But an
>> IDLgrSurface object cannot have two STYLE properties. How
>> can I realize that?
>
> Just as a quick test, I took TEXTURE_SURFACE from my
> web page, and added another surface to the model (I
> called it thatSurface). I performed the same scaling
> to thatSurface that I did to thisSurface. I also set
> the keyword DEPTH_TEST_DISABLE on the model, and I
> added thatSurface to the model AFTER thisSurface.
>
> It worked great, although the grid was a little too fine to
> see the texture very well. Another way I could have done
> this would be to combine a texture image and "grid" image
> with some kind of image blending (see IMAGE_BLEND on my
> web page). Then use this blended image as the texture
> map of the surface. This would allow me to "dial in" the
> grid, as I needed.
>
> Cheers,
>
> David
>
> --
> David Fanning, Ph.D.
> Fanning Software Consulting, Inc.
> Coyote's Guide to IDL Programming: http://www.dfanning.com/
> Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: yy on Thu, 12 October 2006 11:59
		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: Jim Pendleton on Wed, 11 October 2006 20:33
		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: David Fanning on Wed, 11 October 2006 18:03

Previous Topic:	Map parameters for Eta/NAM model
Next Topic:	Re: Map parameters for Eta/NAM model

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 29 03:24:46 PST 2025

Total time taken to generate the page: 0.96180 seconds