comp.lang.idl-pvwave archive: archive » Re: Is it possible to use wire mesh and display the surface as a solid at the same time?

Home » Public Forums » archive » Re: Is it possible to use wire mesh and display the surface as a solid at the same time?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Is it possible to use wire mesh and display the surface as a solid at the same time? [message #50715 is a reply to message #50695]

Wed, 11 October 2006 20:33

Jim Pendleton
Messages: 13
Registered: July 2001

Junior Member

> "David Fanning" <news@dfanning.com> wrote in message
> news:MPG.1f974239bebde4d2989d27@news.frii.com...
>> yy writes:
>>
>> I'm trying to use IDLgrSurface to map a colored image onto an
>> elevation data set. I want to show both the wire mesh such that
>> I can see the curvature of the surface and the solid image data.
...
>
> Just as a quick test, I took TEXTURE_SURFACE from my
> web page, and added another surface to the model (I
> called it thatSurface).
...

And if you use the SHARE_DATA keyword on the second IDLgrSurface's
creation, specifying the reference to the first IDLgrSurface, you can
improve
your memory efficiency, especially if you're working with a large mesh.

Jim P.

Report message to a moderator

[Message index]

		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: yy on Thu, 12 October 2006 11:59
		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: Jim Pendleton on Wed, 11 October 2006 20:33
		Re: Is it possible to use wire mesh and display the surface as a solid at the same time? By: David Fanning on Wed, 11 October 2006 18:03

Previous Topic:	Map parameters for Eta/NAM model
Next Topic:	Re: Map parameters for Eta/NAM model

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:51:52 PDT 2025

Total time taken to generate the page: 0.00406 seconds