comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: !P.SYMSIZE still broken? after 5 years?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: !P.SYMSIZE still broken? after 5 years? [message #50974 is a reply to message #50971] Wed, 25 October 2006 17:12 Go to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Gianguido Cianci writes:

>
> it seems that if I define !P.SIMSYZE=2, in an idl startup file or at
> the prompt, it has no effect on the size plot uses. I couldn't figure
> it out so I logically searched the forum and found this:
>
> http://tinyurl.com/ylnzej
>
> Wot?! same problem but systime(1)-t0 = 2.8e6
>
> So what is going on? did I mess up or is this still an issue?

I thought only MY complaints got on the "low priority" list!
Holes in contour plots, NLEVELS keywords that give an arbitrary
number of levels, decent direct graphics fonts ....

Welcome to the direct graphics dead letter box. :-)

Cheers,

David

P.S. Do you believe in reincarnation? Maybe next time.
This train has come and gone!

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Commutativity of multiplication
Next Topic: Re: Mac 64-bit

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 19:36:14 PDT 2025

Total time taken to generate the page: 0.00389 seconds