comp.lang.idl-pvwave archive: archive » Re: iTools: lines too thick to publish?

Home » Public Forums » archive » Re: iTools: lines too thick to publish?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: iTools: lines too thick to publish? [message #51201 is a reply to message #51192]

Tue, 07 November 2006 09:28

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Dave writes:

> I've just received some feedback from a journal that the figures I
> created with iTools has lines that are simply too thick for
> publication. I saved the figure as a vector-based .eps file so this
> isn't a low-res bitmap.

Actually, what iTools prefer to save is NOT a "low-res"
bitmap, but a very "high-res" bitmap. I wouldn't be
surprised to find it is exactly what you had in mind.
Have you tried it? It will be big, but it will probably
be more accurate than the "low-res" vector output. :-)

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: iTools: lines too thick to publish? By: K. Bowman on Wed, 08 November 2006 06:48
		Re: iTools: lines too thick to publish? By: Benjamin Hornberger on Wed, 08 November 2006 07:59
		Re: iTools: lines too thick to publish? By: Dave[3] on Wed, 08 November 2006 06:10
		Re: iTools: lines too thick to publish? By: K. Bowman on Tue, 07 November 2006 11:00
		Re: iTools: lines too thick to publish? By: David Fanning on Tue, 07 November 2006 09:28

Previous Topic:	Re: Problem with compiling ENVI-BATCH routine
Next Topic:	County boundaries in direct graphics

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 15:58:59 PDT 2025

Total time taken to generate the page: 0.00223 seconds