comp.lang.idl-pvwave archive: archive » !p.multi[0] = ? What's the first element of !p.multi ?

Home » Public Forums » archive » !p.multi[0] = ? What's the first element of !p.multi ?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: !p.multi[0] = ? What's the first element of !p.multi ? [message #52937 is a reply to message #52803]

Mon, 05 March 2007 06:34

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

R.G. Stockwell writes:

> PS .... so, in PS mode, !P,multi=[0,1,2] does not give an
> erase command before plotting the first plot. The erase
> command would create a blank page, wouldn't it?

You would think so, but interestingly I have found that if
the *first* command into a PostScript file is the ERASE
command, that command is not executed. Go figure...

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		!p.multi[0] = ? What's the first element of !p.multi ? By: win.trivit on Sat, 03 March 2007 14:58
		Re: !p.multi[0] = ? What's the first element of !p.multi ? By: David Fanning on Mon, 05 March 2007 06:34
		Re: !p.multi By: David Fanning on Thu, 08 November 2007 06:27

Previous Topic:	!p.multi
Next Topic:	Re: IDL structure to HDF-5

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 09:41:58 PDT 2025

Total time taken to generate the page: 1.51645 seconds