comp.lang.idl-pvwave archive: archive » Re: Fill value problem in MODIS Processing...

Home » Public Forums » archive » Re: Fill value problem in MODIS Processing...

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Fill value problem in MODIS Processing... [message #54554 is a reply to message #54547]

Tue, 26 June 2007 13:24

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

DirtyHarry writes:

> Three weeks have passed since I faced this problem. I thought I could
> solve this problem by myself at first. I checked the source codes ->
> there was no problem. IDL/ENVI has been running perfectly...
> Therefore, I thought this problems was just nothing, but I got stuck
> for over 20 days... I believe it is time to listen to your
> suggestions.
>
> Is there anyone who experienced similar problem like this? Please give
> me any comments or suggestions.

If the program ran perfectly, then I think you can
assume the results are valid. It sounds as though
you don't think the results are valid. In that case,
I think I would start by re-evaluating my assumption
that a program that runs without errors runs "perfectly". :-)

Cheers,

David

"When you have eliminated all which is impossible, then whatever
remains, however improbable, must be the truth." -- Sherlock Holmes

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Fill value problem in MODIS Processing... By: kim20026 on Tue, 26 June 2007 19:47
		Re: Fill value problem in MODIS Processing... By: kim20026 on Tue, 26 June 2007 18:55
		Re: Fill value problem in MODIS Processing... By: MarioIncandenza on Tue, 26 June 2007 18:02
		Re: Fill value problem in MODIS Processing... By: David Fanning on Tue, 26 June 2007 13:24
		Re: Fill value problem in MODIS Processing... By: James Kuyper on Wed, 27 June 2007 10:22
		Re: Fill value problem in MODIS Processing... By: James Kuyper on Wed, 27 June 2007 08:35

Previous Topic:	boxplot
Next Topic:	"Variable is undefined: conversion destination variable."

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:05:40 PDT 2025

Total time taken to generate the page: 0.00437 seconds