comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Question about Plots

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Question about Plots [message #56381 is a reply to message #56205]

Wed, 17 October 2007 07:56

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

MT writes:

> I have a cylindrical detector for gamma rays and I want to
> visualise two points on the diameter of the detector. The points are
> in [x1,y1,z1] and [x2,y2,z2] format. I was planing to use IDL to plot
> the 3d outline of the detector and then draw a line through the two
> points. This is for visualisation only. I tried PlotS procedure but
> that does not seem to be a 3d representation.
>
> How do I go about doing it?

You will have to set the T3D keyword to make PLOTS use
the current 3D coordinate transformation.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Question about Plots By: MT on Mon, 15 October 2007 11:52
		Re: Question about Plots By: David Fanning on Wed, 17 October 2007 07:56

Previous Topic:	Re: source_href in IDLdoc?
Next Topic:	Re: image cut by a shapefile

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 14:06:41 PDT 2025

Total time taken to generate the page: 1.28019 seconds