comp.lang.idl-pvwave archive: archive » Re: fitting after rebinning

Home » Public Forums » archive » Re: fitting after rebinning

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: fitting after rebinning [message #57356 is a reply to message #57355]

Thu, 06 December 2007 13:41

Greg Hennessy
Messages: 45
Registered: November 2005

Member

On 2007-12-06, Brian Larsen <balarsen@gmail.com> wrote:
> After running your code I get a curve fit error...

Well, I had cheated. I had origionally used mpfit2dpeak instead of
gauss2dfit, but then I thought that someone might assert that Craig's
routine had an error, and I'm sure its not his fitting routine that
has an issue, so I swapped out Craig's routine for the faster and
possibly less accurate gauss2dfit. The two routines give the same
answer, even with the convergence message.

Report message to a moderator

[Message index]

		Re: fitting after rebinning By: Greg Hennessy on Thu, 06 December 2007 17:14
		Re: fitting after rebinning By: biophys on Thu, 06 December 2007 16:17
		Re: fitting after rebinning By: Greg Hennessy on Thu, 06 December 2007 14:13
		Re: fitting after rebinning By: David Fanning on Thu, 06 December 2007 13:58
		Re: fitting after rebinning By: Greg Hennessy on Thu, 06 December 2007 13:53
		Re: fitting after rebinning By: David Fanning on Thu, 06 December 2007 13:44
		Re: fitting after rebinning By: Greg Hennessy on Thu, 06 December 2007 13:41
		Re: fitting after rebinning By: Greg Hennessy on Thu, 06 December 2007 13:37
		Re: fitting after rebinning By: Brian Larsen on Thu, 06 December 2007 13:21
		Re: fitting after rebinning By: David Fanning on Thu, 06 December 2007 13:19

Previous Topic:	Centered VIEW in PS file using IDLgrClipboard
Next Topic:	Problem with ENVIZOOM

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 08:58:08 PDT 2025

Total time taken to generate the page: 0.96158 seconds