comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: How to perform the 1-D signal filter?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: How to perform the 1-D signal filter? [message #58551 is a reply to message #58425] Fri, 01 February 2008 17:07 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Kenneth P. Bowman writes:

> You could look at the chapter on FFTs and digital filtering in my IDL
> book (http://idl.tamu.edu). I wrote the chapter in part so that *I*
> could refer to it whenever I need to do a digital filter. :-)

Humm. I found quite a lot of interest in the last three
or four chapters in that book, and had a nice little read
this afternoon. Unlike Chloe, I have no need to impress
anyone anymore, so I'm just going to steal one or two
of those ideas, if you don't mind. :-)

Thanks,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: About IDLffDICOM
Next Topic: Re: county and urban shapefiles

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 14:57:56 PDT 2025

Total time taken to generate the page: 1.12177 seconds