comp.lang.idl-pvwave archive: archive » mpfit: what's different

Home » Public Forums » archive » mpfit: what's different

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: mpfit: what's different [message #58627 is a reply to message #58600]

Mon, 11 February 2008 09:13

Wox
Messages: 184
Registered: August 2006

Senior Member

On 11 Feb 2008 08:39:28 -0500, Craig Markwardt
<craigmnet@REMOVEcow.physics.wisc.edu> wrote:

<snip>
> I'm not sure what this means. I encourage you to consult the primary
> references in the mpfit.pro documentation section.

Thanks, I will.

One question: Is there a way to make sure that the sum of certain
parameters stays below 1? I was looking at the tied and limit
possibilities, but I don't thing they can do this...

Report message to a moderator

[Message index]

		mpfit: what's different By: Wox on Wed, 06 February 2008 08:35
		Re: mpfit: what's different By: Wox on Mon, 11 February 2008 09:13
		Re: mpfit: what's different By: Craig Markwardt on Tue, 12 February 2008 02:19
		Re: mpfit: what's different By: Craig Markwardt on Mon, 11 February 2008 05:39
		Re: mpfit: what's different By: Wox on Tue, 12 February 2008 09:40

Previous Topic:	Re: One ellipse to rule them all
Next Topic:	Array has a corrupted descriptor

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:59:24 PDT 2025

Total time taken to generate the page: 0.00488 seconds