comp.lang.idl-pvwave archive: archive » Re: IDL procedures to get theromdynamic parameters from Soundings

Home » Public Forums » archive » Re: IDL procedures to get theromdynamic parameters from Soundings

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IDL procedures to get theromdynamic parameters from Soundings [message #6016 is a reply to message #6012]

Thu, 11 April 1996 00:00

uphamw
Messages: 1
Registered: April 1996

Junior Member

"Sereno A. Barr-Kumarakulasinghe" <sbarrkum@ic.sunysb.edu> wrote:

>
> Is there a place where I can obtain routines to do the folowing
> from soundings.
>
> 1) Lifting condensation Level
> 1) Level of Free Convection
> 2) Convective Available Potential Energy (CAPE)
>
> Hope somebody can help out.
>
> Regards
>
> Barr-Kum

Try:

AWS/TR-79/006
"The use of the Skew-T, Log P diagram in analysis and forecasting"

This is an Air Force manual (a good one too) that is approved for
public release.

Write to:

U.S. Department of Commerce
National technical information service
Springfield, VA 22161

------------------------------------------------------------ --
Wayne Upham
Meteorology student
U Mass Lowell

============================================================ ==
/
| d(cabin)
|--------------- = (natural) log cabin + C = houseboat
| (cabin)
/

As explained by Dr Kannenburg during a physics recitation.
============================================================ ==

Report message to a moderator

[Message index]

		Re: IDL procedures to get theromdynamic parameters from Soundings By: stricherz on Thu, 11 April 1996 00:00
		Re: IDL procedures to get theromdynamic parameters from Soundings By: uphamw on Thu, 11 April 1996 00:00

Previous Topic:	Re: passing idl structures in call_external ?
Next Topic:	3D plots of data "clouds"

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 16:51:23 PDT 2025

Total time taken to generate the page: 1.51833 seconds