comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: converting a string to an IDL command
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: converting a string to an IDL command [message #62392 is a reply to message #62391] Mon, 08 September 2008 10:16 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
pgrigis@gmail.com writes:

> lots of posts today, did you give up your new job already?
> Not that anybody here would complain about that ... ;-)

No, no. Car troubles. Stuck at home where old habits
die hard. :-)

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: map plotting
Next Topic: Re: inverse the axis

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 11:04:06 PDT 2025

Total time taken to generate the page: 0.56200 seconds