comp.lang.idl-pvwave archive: archive » Re: PLOTS in different windows with different RANGE

Home » Public Forums » archive » Re: PLOTS in different windows with different RANGE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PLOTS in different windows with different RANGE [message #63033 is a reply to message #63029]

Fri, 24 October 2008 00:11

Karlo Janos
Messages: 31
Registered: July 2008

Member

> This is nearly identical to overploting with !P.MULTI
> set:

Indeed my first approach was plotting in a two column multi-plot. Then
I saw, that the data disappears outside the coordinate system in one of
the plots. So I tried two separate windows instead of the multi-plot.
Unfortunately with the same result.

> The secret is saving the correct system variables.

Now I have learned from your example that it is not enough to save
!X.RANGE only, but the whole !X. Thanks!
Best regards

Karlo

Report message to a moderator

[Message index]

		Re: PLOTS in different windows with different RANGE By: David Fanning on Fri, 24 October 2008 05:01
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:11
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:07
		Re: PLOTS in different windows with different RANGE By: David Fanning on Thu, 23 October 2008 09:31
		Re: PLOTS in different windows with different RANGE By: Vince Hradil on Thu, 23 October 2008 08:37

Previous Topic:	QUESTION: is there a command in idl which could clean up memory pieces?
Next Topic:	Re: serial.dll for serial port under IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 22:13:13 PDT 2025

Total time taken to generate the page: 1.20101 seconds