comp.lang.idl-pvwave archive: archive » Re: PLOTS in different windows with different RANGE

Home » Public Forums » archive » Re: PLOTS in different windows with different RANGE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PLOTS in different windows with different RANGE [message #63034 is a reply to message #63033]

Fri, 24 October 2008 00:07

Karlo Janos
Messages: 31
Registered: July 2008

Member

Vince Hradil wrote:

> I'd make an invisible plot to setup my coordinate system, then perform
> the PLOTS
>
> plot, xvals, yvals, /nodata, xstyle=4, ystyle=4
> plots, foobar

Thank you for this hint! /NODATA seems to be an easy way. But since I
would have to call PLOT too often, the program is slowed down. Thus the
trick of David Fanning might be the better choice in my case.
Regards

Karlo

Report message to a moderator

[Message index]

		Re: PLOTS in different windows with different RANGE By: David Fanning on Fri, 24 October 2008 05:01
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:11
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:07
		Re: PLOTS in different windows with different RANGE By: David Fanning on Thu, 23 October 2008 09:31
		Re: PLOTS in different windows with different RANGE By: Vince Hradil on Thu, 23 October 2008 08:37

Previous Topic:	QUESTION: is there a command in idl which could clean up memory pieces?
Next Topic:	Re: serial.dll for serial port under IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:34:55 PDT 2025

Total time taken to generate the page: 0.00375 seconds