comp.lang.idl-pvwave archive: archive » Re: PLOTS in different windows with different RANGE

Home » Public Forums » archive » Re: PLOTS in different windows with different RANGE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PLOTS in different windows with different RANGE [message #63051 is a reply to message #63034]

Thu, 23 October 2008 09:31

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Karlo Janos writes:

> I'd like to plot data points with PLOTS in two different windows with
> different data ranges for the x-axis. The problem is that after the
> second window change (back to window 1) the range is that of window 2,
> so the data points vanish outside the coordinate system.
> I tried to set !X.RANGE manually after each window change, but that is
> not the solution.
> Any idea how to get that working?

This is nearly identical to overploting with !P.MULTI
set:

http://www.dfanning.com/tips/oplot_pmulti.html

The secret is saving the correct system variables.

Cheers,

David
--
David Fanning, Ph.D.
Coyote's Guide to IDL Programming (www.dfanning.com)
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: PLOTS in different windows with different RANGE By: David Fanning on Fri, 24 October 2008 05:01
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:11
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:07
		Re: PLOTS in different windows with different RANGE By: David Fanning on Thu, 23 October 2008 09:31
		Re: PLOTS in different windows with different RANGE By: Vince Hradil on Thu, 23 October 2008 08:37

Previous Topic:	QUESTION: is there a command in idl which could clean up memory pieces?
Next Topic:	Re: serial.dll for serial port under IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:33:45 PDT 2025

Total time taken to generate the page: 0.00465 seconds