comp.lang.idl-pvwave archive: archive » Re: PLOTS in different windows with different RANGE

Home » Public Forums » archive » Re: PLOTS in different windows with different RANGE

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PLOTS in different windows with different RANGE [message #63054 is a reply to message #63051]

Thu, 23 October 2008 08:37

Vince Hradil
Messages: 574
Registered: December 1999

Senior Member

On Oct 23, 10:21 am, "Karlo Janos" <idl.20.beam...@spamgourmet.com>
wrote:
> Hi all!
>
> I'd like to plot data points with PLOTS in two different windows with
> different data ranges for the x-axis. The problem is that after the
> second window change (back to window 1) the range is that of window 2,
> so the data points vanish outside the coordinate system.
> I tried to set !X.RANGE manually after each window change, but that is
> not the solution.
> Any idea how to get that working?
> Best regards
>
> Karlo

I'd make an invisible plot to setup my coordinate system, then perform
the PLOTS

plot, xvals, yvals, /nodata, xstyle=4, ystyle=4
plots, foobar

Report message to a moderator

[Message index]

		Re: PLOTS in different windows with different RANGE By: David Fanning on Fri, 24 October 2008 05:01
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:11
		Re: PLOTS in different windows with different RANGE By: Karlo Janos on Fri, 24 October 2008 00:07
		Re: PLOTS in different windows with different RANGE By: David Fanning on Thu, 23 October 2008 09:31
		Re: PLOTS in different windows with different RANGE By: Vince Hradil on Thu, 23 October 2008 08:37

Previous Topic:	QUESTION: is there a command in idl which could clean up memory pieces?
Next Topic:	Re: serial.dll for serial port under IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:32:19 PDT 2025

Total time taken to generate the page: 0.00533 seconds