comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Re: How to add several *.fit files (matrices) into one output *.fit file?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: How to add several *.fit files (matrices) into one output *.fit file? [message #63411 is a reply to message #63410] Thu, 06 November 2008 09:35 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Griffons writes:

> I downloaded readfits, writefits and the other files required.
> I am not sure what to do next. I compiled and ran readfits and
> writefits, but then what to do?

Usually, the next step is to read the documentation headers.

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: solving equation consisting of points - sort of...
Next Topic: Re: Using make_rt with a custom DLL/DLM

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 04:52:45 PDT 2025

Total time taken to generate the page: 0.39608 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software