comp.lang.idl-pvwave archive: archive » Re: Obtain Pixel values in ENVI and report those to IDL

Home » Public Forums » archive » Re: Obtain Pixel values in ENVI and report those to IDL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Obtain Pixel values in ENVI and report those to IDL [message #64126]

Thu, 04 December 2008 10:27

jeffnettles4870
Messages: 111
Registered: October 2006

Senior Member

On Dec 3, 4:33 pm, david.b.val...@gmail.com wrote:
> I need to obtain pixel values interactively, via my cursor in an ENVI
> displayed image and report those out to IDL so I can read them into
> the REGION_GROW routine. This may seem simple but I can’t figure it
> out.
>
> Thanks for your help.
> Dave

You could also use one of two options if you want to stick to using
ENVI displays:

If you want to have a routine that just gets the current coordinates
under the cursor, then operate on those coordinates only, then you
should probably use DISP_GET_LOCATION.

If you want a routine that continuously updates as the cursor is moved
around in the image display, then you will probably want to set up a
"user defined move" or "user defined motion" routine (i always forget
the difference between the two). See ENVI documentation for those,
they require a preference setting to work.

Jeff

Report message to a moderator

[Message index]

		Re: Obtain Pixel values in ENVI and report those to IDL By: jeffnettles4870 on Thu, 04 December 2008 10:27
		Re: Obtain Pixel values in ENVI and report those to IDL By: Jean H. on Thu, 04 December 2008 07:33
		Re: Obtain Pixel values in ENVI and report those to IDL By: David Fanning on Thu, 04 December 2008 07:20
		Re: Obtain Pixel values in ENVI and report those to IDL By: Jean H. on Thu, 04 December 2008 06:39

Previous Topic:	Coyote Library
Next Topic:	Re: color value interpolation from colorbar

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 16:11:24 PDT 2025

Total time taken to generate the page: 0.79749 seconds