comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Anyone can explain this?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: Anyone can explain this? [message #64262 is a reply to message #64197] Wed, 10 December 2008 09:40 Go to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
xiao writes:

> Sorry, David, But i have another question, I suddenly realized that my
> map did not show the continent line. The continent line was erased by
> the contour . But if I put the map_grid and map_continents after the
> contour, it showed me the error :
> -Current ploting device must have mapping coordinates..
> I think i have used the overplot and noerase key word in contour
> command. But it still does not shown.....

I think the (unneeded) NOERASE keyword in the CONTOUR command
is causing a different set of data coordinates to be established
by the CONTOUR command. You want the data coordinates to be set
by the MAP_SET command. You can either re-issue the MAP_SET command
after you issue the CONTOUR command (to re-establish) the map data
coordinates, or you can take the NOERASE off the CONTOUR command.
I would try the latter first.

Is the data you are trying to contour in latitude and longitude units?

Cheers,

David
--
David Fanning, Ph.D.
Coyote's Guide to IDL Programming (www.dfanning.com)
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Anyone can explain this?
Next Topic: GENERIC XML READER

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Tue Oct 21 14:33:12 PDT 2025

Total time taken to generate the page: 0.72256 seconds