comp.lang.idl-pvwave archive: archive » Re: How to display two images using tvscl

Home » Public Forums » archive » Re: How to display two images using tvscl

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to display two images using tvscl [message #65030 is a reply to message #65028]

Mon, 09 February 2009 15:16

frankosuna
Messages: 31
Registered: February 2008

Member

I'll give this a try. Thanks again!!

On Feb 9, 2:38 pm, David Fanning <n...@dfanning.com> wrote:
> frankosuna writes:
>> I want to display the first image and then superimpose the edge
>> detected pixels but I'm not sure how to go about
>> pulling out the white pixels and then displaying them on top of the
>> supporImage.
>
>> Any ideas?
>
> Loadct, 0, NCOLORS=128
> LoadCT, 2, NCOLORS=128, BOTTOM=128
> TV, Btyscl(image1, TOP=127) + $
> BytScl(image2, TOP=127) + 128B
>
> Cheers,
>
> David
> --
> David Fanning, Ph.D.
> Coyote's Guide to IDL Programming (www.dfanning.com)
> Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 21:19
		Re: How to display two images using tvscl By: frankosuna on Mon, 09 February 2009 17:18
		Re: How to display two images using tvscl By: frankosuna on Mon, 09 February 2009 15:16
		Re: How to display two images using tvscl By: Foldy Lajos on Mon, 09 February 2009 13:44
		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 13:42
		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 13:38
		Re: How to display two images using tvscl By: frankosuna on Wed, 11 February 2009 17:52

Previous Topic:	Colorbar Labels Issue
Next Topic:	why the idlgrwindow select can't performant??!!!

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:28:15 PDT 2025

Total time taken to generate the page: 0.00398 seconds