comp.lang.idl-pvwave archive: archive » Re: How to display two images using tvscl

Home » Public Forums » archive » Re: How to display two images using tvscl

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to display two images using tvscl [message #65036 is a reply to message #65030]

Mon, 09 February 2009 13:44

Foldy Lajos
Messages: 268
Registered: October 2001

Senior Member

On Mon, 9 Feb 2009, frankosuna wrote:

> Hello I have two images:
>
> http://frankosuna.googlepages.com/supportImage.jpg
>
> http://frankosuna.googlepages.com/edgeDetect.jpg
>
> I want to display the first image and then superimpose the edge
> detected pixels but I'm not sure how to go about
> pulling out the white pixels and then displaying them on top of the
> supporImage.
>
> Any ideas?
>
> Thanks,
>
> Frank Osuna
>

Make the edge image bi-level (0b and 255b), then OR the two images.

regards,
lajos

Report message to a moderator

[Message index]

		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 21:19
		Re: How to display two images using tvscl By: frankosuna on Mon, 09 February 2009 17:18
		Re: How to display two images using tvscl By: frankosuna on Mon, 09 February 2009 15:16
		Re: How to display two images using tvscl By: Foldy Lajos on Mon, 09 February 2009 13:44
		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 13:42
		Re: How to display two images using tvscl By: David Fanning on Mon, 09 February 2009 13:38
		Re: How to display two images using tvscl By: frankosuna on Wed, 11 February 2009 17:52

Previous Topic:	Colorbar Labels Issue
Next Topic:	why the idlgrwindow select can't performant??!!!

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 18:08:05 PDT 2025

Total time taken to generate the page: 0.00354 seconds