comp.lang.idl-pvwave archive: archive » Using t3d to perform a reflection

Home » Public Forums » archive » Using t3d to perform a reflection

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Using t3d to perform a reflection [message #66872]

Fri, 19 June 2009 08:30

robintw
Messages: 37
Registered: March 2009

Member

Hi,

I've plotted some polar contour plots, but I've found that by default
the azimuth of 0 (ie. North) is at the bottom (6 on a clockface) and
that an azimuth of 90 on the right (3 on a clockface). I want to
change this so that they are at their normal locations (ie. 0 at the
top, 90 on the right hand side, 180 at the bottom etc). How should I
do this?

I found the t3d procedure, and that seems to have ways of performing
all sorts of transformations excluding reflections. Is there an easy
way to do this using IDL?

Cheers,

Robin
Department of Geography
University of Southampton

Report message to a moderator

[Message index]

Using t3d to perform a reflection

By: robintw on Fri, 19 June 2009 08:30

Previous Topic:	Re: matrix - element extraction
Next Topic:	Re: about color table

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 13:49:23 PDT 2025

Total time taken to generate the page: 0.88149 seconds