comp.lang.idl-pvwave archive: archive » Re: Function to return the current procedure/function

Home » Public Forums » archive » Re: Function to return the current procedure/function

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Function to return the current procedure/function [message #67925 is a reply to message #67922]

Sat, 05 September 2009 06:05

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

maurya writes:

> Is there any function to return the current procedure/function name
> only not all?
>
> There is one function "ROUTINE_INFO" which provide information about
> all currently-compiled procedures and functions. But, I want to get
> the name of the procedure/function using a function (say Routine_Name)
> by calling in the same routine. e.g.
>
> Pro test_plot
>
> plot,findgen(200)
> ;
>
> print, Routine_Name()
>
> end
>
> The print function should return 'test_plot'.

ProgramRootDir does this:

http://www.dfanning.com/programs/programrootdir.pro

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Function to return the current procedure/function By: Maarten[1] on Mon, 07 September 2009 01:02
		Re: Function to return the current procedure/function By: maurya on Sat, 05 September 2009 09:16
		Re: Function to return the current procedure/function By: Heinz Stege on Sat, 05 September 2009 07:04
		Re: Function to return the current procedure/function By: David Fanning on Sat, 05 September 2009 06:05

Previous Topic:	Readu, Writeu Causing Segmentation Fault
Next Topic:	Re: Help, no improvement in FFT speed on a multiprocessor system

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:32:39 PDT 2025

Total time taken to generate the page: 0.00432 seconds