comp.lang.idl-pvwave archive: archive » Re: IDL set

Home » Public Forums » archive » Re: IDL set_plot

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IDL set_plot [message #67940 is a reply to message #67938]

Fri, 04 September 2009 07:06

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Maarten writes:

> There can be only one current graphics device at any time, and thus
> you can generate only one PS file in one run. A possible solution is
> to first run the inner loop, and then run the outer loop.

I'm not exactly sure what "one run" means. It is true
that PostScript files can only be generated one at a time,
but if a "run" is an IDL program, you can generate as many
as you like in that program, as long as you do it one at
a time. You can also generate as many "pages" of PostScript
output as you like in a single PostScript file.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: IDL set_plot By: Maarten[1] on Fri, 04 September 2009 07:53
		Re: IDL set_plot By: David Fanning on Fri, 04 September 2009 07:06
		Re: IDL set_plot By: Maarten[1] on Fri, 04 September 2009 06:25

Previous Topic:	Re: Is it possible to set a string to a veriable name?
Next Topic:	Re: BIL to BSQ in chunks

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 21:42:11 PDT 2025

Total time taken to generate the page: 0.71910 seconds