comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Re: passing parameters to .sav file in IDL VM
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: passing parameters to .sav file in IDL VM [message #68069 is a reply to message #68066] Mon, 21 September 2009 05:25 Go to previous messageGo to previous message
Prashanth is currently offline  Prashanth
Messages: 9
Registered: June 2009
Junior Member
Since I am running it in VM, using print is not a good idea. I will
try to check the result by displaying in a text widget. But that is
not the point here. If it is getting into the if condition it only
means the number of input parameters is less than 3. So, I am more
worried about whats happening to my input parameters at the command
line.

Thank you,
Prashanth

> I'd add a line "print,nparams" at a judicious point...
>
> regards,
> greg

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Breakpoints Missing in IDL 7.1?
Next Topic: Re: Sorting (big) int array: Eliminate for loop

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 19:25:07 PDT 2025

Total time taken to generate the page: 0.00386 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software