comp.lang.idl-pvwave archive: archive » Re: IDL Error GCPC data

Home » Public Forums » archive » Re: IDL Error GCPC data

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IDL Error GCPC data [message #69254 is a reply to message #69252]

Thu, 24 December 2009 08:57

sampton
Messages: 8
Registered: December 2009

Junior Member

Thanks for your reply,
What I use is:
- Type "idl" at the UNIX command prompt to start IDL.
- Type: .run read_v2_1_file.pro to compile the procedures.
- Type: read_V2_1, "Bin_DATA_FILE_NAME", "STRUC"
and I changed the file names inside the pro file accordingly. At the
end no output file is generated, I'm expecting to read a binary file
but no file is generated.
Did I miss something ?

On Dec 24, 3:59 am, Wox <s...@nomail.com> wrote:
> On Wed, 23 Dec 2009 23:27:27 -0800 (PST), sampton <simo2...@gmail.com>
> wrote:
>
>> but can't make it to run properly under idl71
>
> Change *V2.1* in the routine names to something without a ".", for
> example *V2_1*

Report message to a moderator

[Message index]

		Re: IDL Error GCPC data By: David Fanning on Tue, 29 December 2009 11:35
		Re: IDL Error GCPC data By: sampton on Tue, 29 December 2009 11:28
		Re: IDL Error GCPC data By: sampton on Fri, 25 December 2009 09:38
		Re: IDL Error GCPC data By: David Fanning on Thu, 24 December 2009 20:21
		Re: IDL Error GCPC data By: sampton on Thu, 24 December 2009 18:29
		Re: IDL Error GCPC data By: David Fanning on Thu, 24 December 2009 11:07
		Re: IDL Error GCPC data By: sampton on Thu, 24 December 2009 10:18
		Re: IDL Error GCPC data By: David Fanning on Thu, 24 December 2009 09:38
		Re: IDL Error GCPC data By: sampton on Thu, 24 December 2009 08:57
		Re: IDL Error GCPC data By: Wout De Nolf on Thu, 24 December 2009 00:59
		Re: IDL Error GCPC data By: sampton on Mon, 04 January 2010 17:13

Previous Topic:	fitting contours with ellipse
Next Topic:	Re: Reducing a set of curves to a mean curve

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:31:40 PDT 2025

Total time taken to generate the page: 0.00180 seconds