comp.lang.idl-pvwave archive: archive » More problems with Build Project, IDLDE vs IDLRT question

Home » Public Forums » archive » More problems with Build Project, IDLDE vs IDLRT question

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: More problems with Build Project, IDLDE vs IDLRT question [message #69265 is a reply to message #69075]

Wed, 23 December 2009 11:01

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

j.coenia@gmail.com writes:

> In a new IDL session, or after a full reset, the above command works
> just fine! And then Routine_Filepath('myfunction', /EITHER) also will
> work just fine. However, if I then just build the project that
> includes myfunction, and issue the exact same Routine_Filepath
> command, it fails

Is "myfunction" perhaps being evoked in the program
from within a Call_Function call?

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		More problems with Build Project, IDLDE vs IDLRT question By: j.coenia@gmail.com on Tue, 22 December 2009 14:39
		Re: More problems with Build Project, IDLDE vs IDLRT question By: j.coenia@gmail.com on Wed, 23 December 2009 12:57
		Re: More problems with Build Project, IDLDE vs IDLRT question By: David Fanning on Wed, 23 December 2009 11:01
		Re: More problems with Build Project, IDLDE vs IDLRT question By: j.coenia@gmail.com on Wed, 23 December 2009 10:54

Previous Topic:	Re: More problems with Build Project, IDLDE vs IDLRT question
Next Topic:	Re: Writing eps files from iplot

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 16:58:54 PDT 2025

Total time taken to generate the page: 0.87855 seconds