comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » More problems with Build Project, IDLDE vs IDLRT question
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: More problems with Build Project, IDLDE vs IDLRT question [message #69266 is a reply to message #69075] Wed, 23 December 2009 10:54 Go to previous message
j.coenia@gmail.com is currently offline  j.coenia@gmail.com
Messages: 36
Registered: December 2008
Member
>    IDL> Resolve_Routine, 'myfunction', /EITHER

In a new IDL session, or after a full reset, the above command works
just fine! And then Routine_Filepath('myfunction', /EITHER) also will
work just fine. However, if I then just build the project that
includes myfunction, and issue the exact same Routine_Filepath
command, it fails

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: More problems with Build Project, IDLDE vs IDLRT question
Next Topic: Re: Writing eps files from iplot

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 20:08:55 PDT 2025

Total time taken to generate the page: 0.31917 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software