comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: BSQ to BIL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: BSQ to BIL [message #69586 is a reply to message #69576]

Fri, 05 February 2010 12:02

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Hawaiianite writes:

> Second, the write_isis command isn't being recognized by idl.

The WRITE_ISIS command is either a procedure or a function.
You seem to be calling it as if it were both! :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: BSQ to BIL By: Maxwell Peck on Sat, 06 February 2010 13:00
		Re: BSQ to BIL By: David Fanning on Fri, 05 February 2010 12:02
		Re: BSQ to BIL By: penteado on Mon, 08 February 2010 12:53
		Re: BSQ to BIL By: jtmcahill on Mon, 08 February 2010 08:01

Previous Topic:	Shout Out to Mark Hadfield
Next Topic:	oplot

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 14:10:08 PDT 2025

Total time taken to generate the page: 0.00434 seconds