comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: BSQ to BIL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: BSQ to BIL [message #69757 is a reply to message #69576]

Mon, 08 February 2010 12:53

penteado
Messages: 866
Registered: February 2018

Senior Member
Administrator

On Feb 6, 7:00 pm, Maxwell Peck <maxjp...@gmail.com> wrote:
>> a=isis_write, r_fid,filename + '_bil.cub'
>
> Hi,
>
> I'm not sure where ISIS_WRITE comes from (it's not an ENVI function as
> far as i know), or what your actual error is, but it is unlikely it
> will accept the r_fid keyword. You will probably need to use the
> ENVI_GET_DATA function to put the band in an IDL variable and output
> it from that. If there is a lot of data you may need to use tiling
> (all in the ENVI Programmers guide).
>
> Max

This is not directly related to the original question, but if anyone
is interested, I have a reader and writer for ISIS cubes. The main
reasons I wrote them are the awkward interface of the ISIS routines,
their lack of ability to do more complicated things than just reading
or writing core bands, and to not need to install ISIS just to read
and write cubes from IDL. However, my routines presently only support
BSQ.

Report message to a moderator

[Message index]

		Re: BSQ to BIL By: Maxwell Peck on Sat, 06 February 2010 13:00
		Re: BSQ to BIL By: David Fanning on Fri, 05 February 2010 12:02
		Re: BSQ to BIL By: penteado on Mon, 08 February 2010 12:53
		Re: BSQ to BIL By: jtmcahill on Mon, 08 February 2010 08:01

Previous Topic:	Shout Out to Mark Hadfield
Next Topic:	oplot

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 30 09:49:28 PST 2025

Total time taken to generate the page: 0.32133 seconds