comp.lang.idl-pvwave archive: archive » Re: how to display on the unix system

Home » Public Forums » archive » Re: how to display on the unix system

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: how to display on the unix system [message #70114 is a reply to message #70083]

Wed, 10 March 2010 15:19

pgrigis
Messages: 436
Registered: September 2007

Senior Member

On Mar 10, 4:59 pm, Mok <jungbin...@hotmail.com> wrote:
> Dear all
> I used to display IDL on the window system using ‘window’ such as,
>
> window, 0, xs=900, ys=900
>
> Now, however, I have to display my results on the unix system.
> But if I use ‘window, 0’ on the unix system, there is errors like
>
> % WINDOW: Unable to connect to X Windows display: :0.0
> % WINDOW: Unable to open X Windows display.
> Is your DISPLAY environment variable set correctly?
>

Try using

ssh -X user@host

when you are connecting to the machine where you run IDL on.

Ciao,
Paolo

> I am not familiar to use IDL on the unix system. So could anyone let
> me know how to display on the unix system?
> Thank you very much in advance.

Report message to a moderator

[Message index]

		Re: how to display on the unix system By: penteado on Sat, 13 March 2010 08:24
		Re: how to display on the unix system By: Nick[1] on Fri, 12 March 2010 20:09
		Re: how to display on the unix system By: pgrigis on Wed, 10 March 2010 15:19
		Re: how to display on the unix system By: penteado on Wed, 10 March 2010 14:24

Previous Topic:	Re: rejecting a few pixel values from an array of pixel values
Next Topic:	Re: Proper Map Label Clipping

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 03:02:33 PDT 2025

Total time taken to generate the page: 0.47918 seconds