comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: changing the color of a plot
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: changing the color of a plot [message #71221 is a reply to message #71220] Fri, 04 June 2010 10:35 Go to previous messageGo to previous message
penteado is currently offline  penteado
Messages: 866
Registered: February 2018
Senior Member
Administrator
On Jun 4, 2:19 pm, Hassan <hkhav...@gmail.com> wrote:
> Thanks, it should be the right thing I need but I couldn't run it, it
> comes with the following errors:
>  Line 496: ok = Error_Message(/Traceback)
> Line 538: decomposedState = DecomposedColor(DEPTH=theDepth)
> Line 827: theColor = PickColorName(Filename=filename, _Extra=extra,
> Cancel=cancelled, BREWER=brewer)
> Line 843: theColor = PickColorName(theColor, Filename=filename,
> _Extra=extra, Cancel=cancelled, BREWER=brewer)
> Line 847: theColor = PickColorName(theColor, Filename=filename,
> _Extra=extra, Cancel=cancelled, BREWER=brewer)

You should say what the errors are, not just where they happen.
Especially when they are inside a well tested routine, which everybody
knows that normally works.

Though in this case I would guess the problem is you did not download
error_message(), decomposedcolor() and pickcolorname(), which
fsc_color uses (as informed in its documentation).
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Contour data with two different lon/lat grids onto the same map projection
Next Topic: WSDL - Webservices access from IDL

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 17:34:21 PDT 2025

Total time taken to generate the page: 0.00477 seconds