comp.lang.idl-pvwave archive: archive » Re: call ENVI menu routines

Home » Public Forums » archive » Re: call ENVI menu routines

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: call ENVI menu routines [message #72621 is a reply to message #72619]

Wed, 22 September 2010 11:39

rogass
Messages: 200
Registered: April 2008

Senior Member

On 22 Sep., 20:17, Mort Canty <m.ca...@fz-juelich.de> wrote:
> Am 22.09.2010 18:28, schrieb chris:
>
>> Hi,
>> is it possible to call ENVI routines from IDL directly, e.g. Basic
>> Tools/Stretch Data, so that the specific menu will be opened?
>
>> Thanks in advance
>
>> CR
>
> Well, you can certainly access just about every ENVI menu routine from
> IDL by calling the corresponding "DOIT", e.g.,
>
> ENVI_DOIT, STRETCH_DOIT, FID=FID, ...
>
> but you have to supply everything that you would have otherwise entered
> into the menu as keywords.
>
> Mort

Dear Mort, dear David,
i know how to use ENVI routines from IDL, but some routines have
limitations. The same routines are not limited if you would call them
from the ENVI menu. The stretching routine was only an example. Any
other ideas?

Best regards

CR

Report message to a moderator

[Message index]

		Re: call ENVI menu routines By: David Fanning on Thu, 23 September 2010 05:35
		Re: call ENVI menu routines By: Maxwell Peck on Thu, 23 September 2010 01:23
		Re: call ENVI menu routines By: David Fanning on Wed, 22 September 2010 15:07
		Re: call ENVI menu routines By: Maxwell Peck on Wed, 22 September 2010 14:44
		Re: call ENVI menu routines By: David Fanning on Wed, 22 September 2010 11:55
		Re: call ENVI menu routines By: David Fanning on Wed, 22 September 2010 11:45
		Re: call ENVI menu routines By: rogass on Wed, 22 September 2010 11:39
		Re: call ENVI menu routines By: Mort Canty on Wed, 22 September 2010 11:17
		Re: call ENVI menu routines By: David Fanning on Wed, 22 September 2010 09:38

Previous Topic:	isotropic keyword for surface?
Next Topic:	Re: isotropic keyword for surface?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 20:13:19 PDT 2025

Total time taken to generate the page: 0.05216 seconds