comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: Z-Graphics Buffer Resolution
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: Z-Graphics Buffer Resolution [message #73170 is a reply to message #73169] Thu, 28 October 2010 09:24 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Heinz Stege writes:

> I'm not sure, if I'm getting something wrong. You can change the
> character size with the device procedure:
> device,set_character_size=[x_ch_size,y_ch_size]

I should point out, too, that those of us with aging
eyesight are well familiar with this method of setting
the character size. You will find this command in almost
of our IDL start-up files. :-)

Cheers,

David

P.S. Let's just say when I see a monitor size larger
than about 1280, I know that person is under 40. :-)

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: the "real" screen size
Next Topic: real screen size. multiple monitors.

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 14:03:50 PDT 2025

Total time taken to generate the page: 0.08247 seconds