comp.lang.idl-pvwave archive: archive » Re: Good-bye Contour Command

Home » Public Forums » archive » Re: Good-bye Contour Command

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Good-bye Contour Command [message #73540 is a reply to message #73539]

Fri, 12 November 2010 11:11

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Paul writes:

> I tried:
> fsc_contour, indgen(25,25), /fill
> fsc_contour, indgen(25,25), /cell_fill
> My axes got covered up with cell_fill.

Ah, yes. I was was trying to limit the number of Contour
keywords I needed to "trap". I was trying to finesse
the Cell_Fill keyword, but I didn't think of this
scenario. Easily fixed in about two minutes. :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Good-bye Contour Command By: SonicKenking on Sun, 14 November 2010 15:01
		Re: Good-bye Contour Command By: Jeremy Bailin on Fri, 12 November 2010 19:34
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 14:47
		Re: Good-bye Contour Command By: R.G.Stockwell on Fri, 12 November 2010 13:53
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 12:58
		Re: Good-bye Contour Command By: jeanh on Fri, 12 November 2010 12:54
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 12:09
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 12:08
		Re: Good-bye Contour Command By: Jeremy Bailin on Fri, 12 November 2010 11:57
		Re: Good-bye Contour Command By: Jeremy Bailin on Fri, 12 November 2010 11:54
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 11:24
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 11:11
		Re: Good-bye Contour Command By: Paul[3] on Fri, 12 November 2010 11:02
		Re: Good-bye Contour Command By: David Fanning on Fri, 12 November 2010 07:28
		Re: Good-bye Contour Command By: Ammar Yusuf on Fri, 12 November 2010 07:24

Previous Topic:	Re: display the angstrom symbol to the power of -1 in a widget_label
Next Topic:	Re: run .sav file with -args

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 20:10:02 PDT 2025

Total time taken to generate the page: 0.40163 seconds