comp.lang.idl-pvwave archive: archive » Help with fsc

Home » Public Forums » archive » Help with fsc_plot

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Help with fsc_plot [message #73950 is a reply to message #73861]

Wed, 08 December 2010 07:49

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

David Fanning writes:

> Well, except of course it is not in a resizeable graphics
> window. If you want that, you will have to type
> this for a short while more:
>
> IDL> FSC_Window, 'FSC_Plot', findgen(11)

Oh, the hell with it! I'll just add a WINDOW keyword
to all of these commands so that if you want to see
a plot, contour, surface, etc in a resizeable graphics
window, you just set the /WINDOW keyword on the command.
Check back in about a half hour. :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Help with fsc_plot By: rogass on Wed, 08 December 2010 05:24
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 08:34
		Re: Help with fsc_plot By: rogass on Wed, 08 December 2010 08:20
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 08:07
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 07:49
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 07:39
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 07:33
		Re: Help with fsc_plot By: rogass on Wed, 08 December 2010 07:25
		Re: Help with fsc_plot By: David Fanning on Wed, 08 December 2010 05:53

Previous Topic:	Saving Large(ish) PDF's with IMAGE() crashes IDL completely
Next Topic:	localising IDL programs

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:02:02 PDT 2025

Total time taken to generate the page: 0.00449 seconds