comp.lang.idl-pvwave archive: archive » Reading and saving a file

Home » Public Forums » archive » Reading and saving a file

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Reading and saving a file [message #74702 is a reply to message #74646]

Thu, 27 January 2011 10:18

penteado
Messages: 866
Registered: February 2018

Senior Member
Administrator

On Jan 27, 3:23 pm, David Fanning <n...@dfanning.com> wrote:
>> Though I am a bit surpised at how fast Giovanna ran out of
>> LUNs seeing she was trying to write out a single file...
>
> Yeah, you would think a hundred or so would be enough,
> but it never is. ;-)

I got very annoyed by the low limit when working with several
IDL_Savefile objects. Apparently they also used some limited unit
number. I intended to keep an array of those objects, to access
whatever file the application needed. But because of the limit I had
to revert to creating the objects on demand, on each access.
Fortunately, the application only had to do occasional large accesses,
not frequent small reads.

Report message to a moderator

[Message index]

		Reading and saving a file By: Giovanna on Wed, 26 January 2011 05:25
		Re: Reading and saving a file By: Giovanna on Fri, 28 January 2011 03:45
		Re: Reading and saving a file By: penteado on Thu, 27 January 2011 10:18
		Re: Reading and saving a file By: Giovanna on Thu, 27 January 2011 09:54
		Re: Reading and saving a file By: David Fanning on Thu, 27 January 2011 09:23
		Re: Reading and saving a file By: pgrigis on Thu, 27 January 2011 09:18
		Re: Reading and saving a file By: David Fanning on Thu, 27 January 2011 08:42

Previous Topic:	DLM Woes
Next Topic:	save in idl 8 / read in idl 7

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:52:22 PDT 2025

Total time taken to generate the page: 0.00244 seconds