comp.lang.idl-pvwave archive: archive » object programming question

Home » Public Forums » archive » object programming question

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Object Programming [message #75963 is a reply to message #57167]

Wed, 11 May 2011 12:23

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Michael Galloy writes:

> Wait (never mind my other post), you are passing two parameters to
> Foo::init!

I guess that's right. I usually check to see if parameters
are undefined or not. In this case, because the actual programs
are wrappers to the PLOT command, I wanted to know how many
there were. Odd that I haven't run into this before, though. :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		object programming question By: markb77 on Tue, 04 December 2007 12:54
		Re: Object Programming By: David Fanning on Wed, 11 May 2011 15:47
		Re: Object Programming By: David Fanning on Wed, 11 May 2011 12:23
		Re: Object Programming By: penteado on Thu, 12 May 2011 12:41
		Re: Object Programming By: Michael Galloy on Wed, 11 May 2011 12:12
		Re: Object Programming By: Michael Galloy on Wed, 11 May 2011 12:11
		Re: Object Programming By: David Fanning on Wed, 11 May 2011 12:07

Previous Topic:	Re: Creating an ordered 'blob' ROI from a messy 'criss-crossed' ROI....
Next Topic:	Object Programming

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:44:20 PDT 2025

Total time taken to generate the page: 0.00350 seconds