comp.lang.idl-pvwave archive: archive » Starting location in histoplot?

Home » Public Forums » archive » Starting location in histoplot?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Starting location in histoplot? [message #76580]

Mon, 13 June 2011 12:07

TimB
Messages: 6
Registered: April 2011

Junior Member

I'm trying to compare two different samples using the histoplot
command. My problem is that the two different histograms (sample 1 and
sample 2) are slightly offset from each other. This is due to the two
samples having slightly different minimum values. I'm plotting from
0-100, in one sample the minimum value is say 1 and in the other its
say 3. If I set the binsize to 5 for both, the first histogram
location is 1-6 while the second is 3-8. I would like these to be the
same, by specifying an initial starting point of 0. So for both sets
the first bin goes from 0-5. Is this possible? I've noticed in the
histoplot documentation there is an output keyword LOCATIONS which
tells the starting location of each bin but I haven't found anything
to set the location of the first bin.

Thanks, Tim

Report message to a moderator

[Message index]

Starting location in histoplot?

By: TimB on Mon, 13 June 2011 12:07

Previous Topic:	Can't set brakpoints using emacs idlwave_shell
Next Topic:	cgPlot: /ISOTROPIC clobbers POSITION

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 23:55:55 PDT 2025

Total time taken to generate the page: 0.00182 seconds