comp.lang.idl-pvwave archive: archive » Strange behaviour ? of Subscript range values of the form low:high

Home » Public Forums » archive » Strange behaviour ? of Subscript range values of the form low:high

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Strange behaviour ? of Subscript range values of the form low:high [message #76612 is a reply to message #76550]

Tue, 21 June 2011 10:53

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

LNpellen writes:

> So the "doseTempFull[x1:x2,y1:y2]=doseTemp" works in command line, but
> not in the code..... I understand nothing.

I would like to see not a PRINT of these four
variables, but a HELP. I still think these are
not scalars, but vectors.

Help, x1, x2, y1, y2

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thue. ("Perhaps thos speakest truth.")

Report message to a moderator

[Message index]

		Strange behaviour ? of Subscript range values of the form low:high By: LNpellen on Wed, 15 June 2011 23:28
		Re: Strange behaviour ? of Subscript range values of the form low:high By: David Fanning on Tue, 21 June 2011 10:53
		Re: Strange behaviour ? of Subscript range values of the form low:high By: LNpellen on Tue, 21 June 2011 22:36
		Re: Strange behaviour ? of Subscript range values of the form low:high By: Brian Daniel on Tue, 21 June 2011 04:22

Previous Topic:	IDL IMAGE NAVIGATION
Next Topic:	Re: Formatted printf output

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 08:53:33 PDT 2025

Total time taken to generate the page: 0.08298 seconds