comp.lang.idl-pvwave archive: archive » Re: Contour Plot Issues

Home » Public Forums » archive » Re: Contour Plot Issues

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Contour Plot Issues [message #80840 is a reply to message #80830]

Thu, 12 July 2012 15:30

DavidF[1]
Messages: 94
Registered: April 2012

Member

ecat...@gmail.com writes:

> Does the aspect keyword just keep the aspect ratio of the contour plot the same?

The ASPECT keyword should be used to set the aspect ratio of the plot to whatever aspect it is you want. If you want 5 units in Y and 10 units in X, then the aspect ratio of 5./10. If you have 10 units of Y and 5 units of X, then the aspect ratio you want is 10./5. You will have to decide the aspect ratio based on the X and Y ranges of your plot. In your original post, you had these the same, so I suggested an aspect ratio of 1.0.

Cheers,

David

Report message to a moderator

[Message index]

		Re: Contour Plot Issues By: David Fanning on Fri, 13 July 2012 17:17
		Re: Contour Plot Issues By: Oana Coman on Fri, 13 July 2012 14:57
		Re: Contour Plot Issues By: David Fanning on Fri, 13 July 2012 14:11
		Re: Contour Plot Issues By: Oana Coman on Fri, 13 July 2012 13:42
		Re: Contour Plot Issues By: David Fanning on Fri, 13 July 2012 12:33
		Re: Contour Plot Issues By: Oana Coman on Fri, 13 July 2012 12:25
		Re: Contour Plot Issues By: DavidF[1] on Thu, 12 July 2012 15:30
		Re: Contour Plot Issues By: Oana Coman on Thu, 12 July 2012 14:59
		Re: Contour Plot Issues By: David Fanning on Thu, 12 July 2012 13:44

Previous Topic:	Fastest way to list combinations
Next Topic:	Re: Array Integration

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 18:08:27 PDT 2025

Total time taken to generate the page: 1.76080 seconds